This work is a contribution in the field of the relationship between H content, H bonding configuration and voids in hydrogenated a-Si single layers deposited by radio frequency (RF) sputtering and subsequently annealed. It was prompted by the need to improve understanding of our previous results about the presence of blisters in hydrogenated a-Si/a-Ge multilayers sputtered in the same way and submitted to annealing with the aim to produce the a-SiGe alloy by Si and Ge diffusion and intermixing [19, 20]. It is reported here that annealing of the single Pictilisib purchase a-Si layers causes the voids to grow

to such a size to form surface blisters detectable by AFM (atomic force microscopy). By using infrared (IR) spectroscopy, it is shown that the annealing causes the formation of (Si-H) n clusters and (Si-H2) n (n ≥ 1) polymers covering the surface of voids. It is then argued that the blisters grow from such voids by accumulation of molecular H2 that had formed by reaction between H atoms released from the (Si-H)

n clusters and (Si-H2) n (n ≥ 1) polymers. The results reported Selleckchem LY2874455 here support and confirm our previous hypothesis that ascribed the blisters in a-Si/a-Ge multilayers to the formation of bubbles containing molecular H2[19, 20]. Methods The a-Si layers have been sputtered at a rate of 6.3 nm/min from a high-purity crystalline silicon target in a high-vacuum sputtering apparatus (Leybold Z400, Fergutec, Valkenswaard, Tideglusib The Netherlands) reaching a base find more pressure better than 5 × 10−5 Pa by a turbo molecular pump. The target was coupled to a RF generator (13.56 MHz) via a network for impedance matching between the generator and its load. The substrate was polished (100) silicon wafer and at a distance of 50 mm away from the target. The layer thickness was approximately 400 nm. Sputtering has been done with a mixture of high-purity argon and hydrogen gases. Both gases have been introduced continuously into the chamber by means of electronically adjustable flow controls.

A 1,500-V dc wall potential has been applied to sputter the targets under a plasma pressure of 2 Pa. The samples were annealed in high-purity (99.999%) argon at 350°C for 1 and 4 h. Controlled layer hydrogenation has been obtained by allowing H to flow continuously into the deposition chamber at different flow rates, namely 0.4, 0.8 and 1.5 ml/min, corresponding to an effective H incorporation in the as-deposited layers of 10.8, 14.7 and 17.6 at.%, respectively, as determined by elastic recoil detection analysis (ERDA). The ERDA measurements were performed with the 1.6 MeV 4He+ beam at the 5 MeV Van de Graaff accelerator of Budapest on a-Si layers 40-nm thick. The recoiled H signal was collected by an Si detector placed at 10° detecting angle to the beam direction, with the sample tilted 85° to the normal.