Gold-coated, reflective probes (NSG10) were used with an intermed

Gold-coated, reflective probes (NSG10) were used with an intermediate spring constant k = 11.5 N/m, a maximum tip radius of curvature of 10 nm, and a resonance frequency of 190 to 325 kHz (Europe MicroMasch, Tallinn, Estonia). Images were captured using the tapping mode at ambient conditions (room temperature 24°C ± 1°C and relative

humidity 38% ± 5%). After landing with tip on the sample surface, a damping ratio (A sp/A 0) of 0.5 to 0.6 and a line frequency of 0.25 to 0.6 Hz were optimized for imaging. The AFM was placed on a vibration isolation table (TS-150, Table Stable, Zwillikon, GDC-0941 supplier Switzerland) to eliminate external vibrational noise. Image processing and root-mean-square (RMS) roughness S q calculations were carried out using the scanning probe image processor program (SPIP™, Image Metrology A/S, Hørsholm, Denmark). Before calculation, images were plane-corrected and the ISO 11562 Gaussian profile filter was implemented. selleck products LXH254 results and discussion TiO2 nanoparticle coatings on paperboard exhibit superhydrophobicity (water contact angle above 160°) that can be converted into a highly hydrophilic surface (water contact angle below 20°) by ultraviolet (UV) illumination via the photocatalytic activity of TiO2

as presented in Figure 2. The crystalline form of the LFS-deposited TiO2 nanoparticles is mainly anatase [22], analyzed from the TEM diffraction pattern. UV light induces free radicals and photocatalytic oxidation that change the surface chemistry of nanoparticles from hydrophobic to Methamphetamine hydrophilic. In our previous study [13], we used X-ray photoelectron spectroscopy (XPS) to study the mechanisms of such wettability conversion: after the UV irradiation, increased values of both O/C and O/Ti ratios were observed. This corresponds to the increased amount of hydroxyl groups on the outermost TiO2 nanoparticle surface. Furthermore, our time-of-flight secondary ion mass spectrometry (ToF-SIMS) analysis

[14] was in agreement with the XPS results with decreased relative amounts of hydrocarbons after the UV irradiation. The surface superhydrophobicity can be recovered by a heat treatment. After the heat treatment, the O/C and O/Ti ratios decreased, and the highly resolved spectra of O 1s verified the decreased amount of oxygen related to the hydroxyl groups [13]. A similar change is observed in the ToF-SIMS spectra [14] with increased relative amounts of hydrocarbon chains originating from the volatile organic compounds used in the base paper substrate. We have previously shown that surface wettability can be alternated between wetting and non-wetting states for several cycles, and the observed changes in wettability correlate well with the changes in the surface chemistry of the TiO2 nanoparticle-coated surface [13, 14]. Figure 2 Water contact angles as a function of the number of calendering nips. For TiO2 nanoparticle-coated and the reference paperboard.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>