“
“We present a combined experimental and computational study that probes the thermoelectric and electrical transport properties of molecular junctions. Experiments were performed on junctions created by trapping aromatic molecules between gold electrodes. The end groups (-SH, -NC) of the aromatic molecules were systematically varied to study the effect of contact coupling strength and contact chemistry. When the coupling of the molecule with one of the electrodes was reduced by switching the terminal chemistry from -SH to -H, the electrical conductance of molecular junctions

decreased by an order of magnitude, whereas the thermopower varied by only a few percent. This has been predicted computationally in the past and is experimentally demonstrated for the first time. Further, our experiments and computational modeling indicate the prospect of tuning thermoelectric selleckchem properties Linsitinib inhibitor at the molecular scale. In particular, the thiol-terminated aromatic molecular junctions revealed a positive thermopower that

increased linearly with length. This positive thermopower is associated with charge transport primarily through the highest occupied molecular orbital, as shown by our computational results. In contrast, a negative thermopower was observed for a corresponding molecular junction terminated by an isocyanide group due to charge transport primarily through the lowest unoccupied molecular orbital.”
“A modelling study on the anaerobic digestion process of a synthetic medium-strength wastewater containing molasses as a carbon source was carried out at different influent conditions. The digestion was conducted in a laboratory-scale hybrid anaerobic baffled reactor with

three compartments and a working volume of 54 L, which operated at mesophilic temperature (35 degrees C). Two different kinetic models (one model was based on completely stirred tank reactors (CSTR) in series and the other an axial diffusion or FG-4592 mouse dispersion model typical of deviations of plug-flow reactors), were assessed and compared to simulate the organic matter removal or fractional conversion. The kinetic constant (k) obtained by using the CSTR in series model was 0.60 +/- 0.07 h(-1), while the kinetic parameter achieved with the dispersion model was 0.67 +/- 0.06 h(-1), the dispersion coefficient (D) being 46. The flow pattern observed in the reactor studied was intermediate between plug-flow and CSTR in series systems, although the plug-flow system was somewhat predominant. The dispersion model allowed for a better fit of the experimental results of fractional conversions with deviations lower than 8% between the experimental and theoretical values. By contrast, the CSTR in series model predicted the behaviour of the reactor somewhat less accurately showing deviations lower than 10% between the experimental and theoretical values of the fractional conversion.