The study was approved by the Institutional Committee for Animal

The study was approved by the Institutional Committee for Animal Care and Use, Health Sciences Center, Federal University of Rio de Janeiro (Protocol no. IBCCF 046). A suspension of 8 mg of particles/m3 of air was obtained by ultrasonicating 5 mg of the collected dust in 83.3 mL of sterile saline solution (NaCl 0.9%). The dose was calculated based on the body chamber volume (7 L) and on the airflow of the nebulizer (1 mL/min), taking into consideration the high dose reported by Fritschi et al. (2001). The particulate matter was digested in a HNO3–HClO4 mixture and after dissolution was brought to a final volume of 15 mL of HCl 0.1 M. The Y-27632 datasheet extract was analyzed by flame atomic absorption spectroscopy (VARIAN AA1475, Varian,

Inc., Palo Alto, CA, USA) following recommended standard operating procedures (Varian, 1981)

and previous reports (Trindade et al., 1981 and Azcue et al., 1988). Trace elements, nickel (Ni), manganese (Mn), aluminum (Al), iron (Fe), lead (Pb), chromium (Cr), cadmium (Cd), copper (Cu), zinc (Zn) and mercury (Hg), were measured and the results expressed as μg/g of particles. Three independent samples of the particulate matter were analyzed for this purpose. The distribution of particle sizes, as measured by their volume and surface, and the diameters encompassing 90%, 50% and 10% of the particulate matter were determined by laser diffraction (Long Bench Mastersizer S, Malvern Instruments Ltd., Malvern, Worcestershire, United Kingdom). The particulate matter was visualized by scanning electron microscopy (JEOL 5310, Tokyo, Japan). Twenty-four hours after exposure to either aerosolized sterile saline solution SCR7 clinical trial (CS and ES) or to 8 mg/m3 of aluminum dust (CA and EA) in a whole-body chamber during 1 h (1 mL/min), the animals were sedated with diazepam (1 mg i.p.), anesthetized with pentobarbital sodium (20 mg/kg body selleck kinase inhibitor weight i.p.), placed in the supine position on a surgical table, tracheotomized, and a snugly fitting cannula (0.8 mm ID) was introduced into the trachea. The animals were then paralyzed with pancuronium bromide

(0.1 mg/kg) and their anterior chest wall was surgically removed. A pneumotachograph (1.5 mm ID, length = 4.2 cm, distance between side ports = 2.1 cm) (Mortola and Novoraj, 1983) was connected to the tracheal cannula for the measurements of airflow (V′). Tidal volume (VT) was determined by digital integration of the flow signal. The pressure gradient across the pneumotachograph was determined by a Validyne MP45-2 differential pressure transducer (Engineering Corp, Northridge, CA, USA). The flow resistance of the equipment (Req), tracheal cannula included, was constant up to flow rates of 26 mL/s and amounted to 0.12 cmH2O/mL/s. Equipment resistive pressure (= ReqV′) was subtracted from pulmonary resistive pressure so that the present results represent intrinsic values. Transpulmonary pressure was measured with a Validyne MP-45 differential pressure transducer (Engineering Corp, Northridge, CA, USA).

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>